Filter
Top Products
20
1
Press the icon (B4) (fig. 7) and select the pre-ground coffee function.
2
Extract the machine by pulling it outwards using the handles.
3
Lift the central lid, place one measure of preground coffee in the funnel (fig. 19), push the
appliance in then proceed as described in the section “Making coffee using coffee beans”.
Note: you can make just one coffee at a time by pressing the icon (B10) (fig. 12).
4
After using the machine with pre-ground coffee, to go back to making coffee using beans,
deactivate the pre-ground coffee function by pressing the
icon (B4) (fig. 7).
Never introduce pre-ground coffee when the machine is off or it could spread through the inside
of the appliance.
Never add more than 1 measure, otherwise the appliance will not make the coffee.
Use the measure provided only.
Introduce only pre-ground coffee for espresso coffee machines into the
funnel.
If more than one measure of pre-ground coffee is used and the funnel
clogs, push the coffee down with a knife (fig. 21) then remove and clean
the brewing unit and machine as described in the “Cleaning the brewing
unit” section.
Delivering hot water
Always make sure the appliance is ready.
Turn the cappuccino maker outwards and place a container underneath
(fig. 5).
Press the icon (B13) (fig. 20). The appliance displays: “HOT WATER PRESS OK”. Press the
OK icon (B9) again and hot water is delivered from the cappuccino maker into the container
underneath. You should not deliver hot water for more than 2 minutes at a time.
To interrupt, press the
icon (B13) or the ESC icon (B6). The appliance stops delivery once the
set quantity is reached.
Changing the quantity of hot water
The machine is set by default to automatically delivery 200 ml of hot water.
To change these quantities, proceed as follows:
1
Place a container underneath the cappuccino maker (fig. 3).
2
Press the icon (B2) to enter the menu (fig. 15) or press the icons (B7) and (B8) (fig. 2)
until “PROGRAM HOT WATER” is displayed.
3
Press the OK icon (B9) to confirm.
4
Select the required quantity of water by pressing the icons (B7) and (B8). The progress bar
shows the quantity of water selected.
5
Press the OK icon (B9) to confirm (or the ESC icon (B6) to cancel the operation.
6
Press the ESC icon (B6) (fig. 18) twice to exit the menu.
The appliance is now reprogrammed with the new settings and is ready.
Making co ee using pre-ground co ee
EN