Filter
Top Products
27
Changing coffee temperature
To change coffee temperature, proceed as follows:
1
Press the icon (B2) to enter the menu and then the icons (B7) and (B8) until
“TEMPERATURE” is displayed.
2
Press the OK icon (B9).
3
Press the icons (B7) and (B8) to select the required coffee temperature from low, medium
and high.
4
Press the OK button (B9) to confirm the temperature selected.
5
Press the ESC icon (B6) to exit the menu.
Setting water hardness
The operating period can be extended if required, making descaling less frequent by
programming the machine on the basis of the real lime content in the water used.
Proceed as follows:
1
Remove the “Total Hardness Test” strip (attached to this manual) from its packaging then dip it
fully in the water for a few seconds, Then remove and wait about 30 seconds (until it changes
colour and forms red squares).
2
Turn the appliance on by pressing the ON/OFF/stand-by button (A7).
3
Press the icon (B2) to enter the menu and then the icons (B7) and (B8) until “WATER
HARDNESS” is displayed.
4
Press the OK icon (B9).
5
Press the icons (B7) and (B8) until the number coincides with the number of red squares on
the test strip (for example, if there are 3 red squares on the test strip, select the message “WATER
HARDNESS 3” .
6
Press the OK icon (B9) to confirm. The coffee maker is now programmed to provide the descale
warning when actually necessary.
Changing the quantity of coffee
For instructions on programming coffee, see section ‘Making coffee using coffee beans’, under
Changing the quantity of hot water
For instructions, see section ‘Making coffee using pre-ground coffee’.
Changing and setting menu parameters
EN