Filter
Top Products
14
Coffee has been used to factory test the appliance and it is therefore completely normal for there
to be traces of coffee in the mill.
Customise water hardness as soon as possible following the instructions in section ‘Changing
and setting menu parameters’, under “Setting water hardness”.
1
Connect the appliance to the mains supply. Set the required language.
2
To set the language, use the icons (B7 and B8) to choose the required language (fig. 2). When
the message “PRESS OK TO CHOOSE ENGLISH” is displayed, press the OK icon (B9) (fig. 3) for
3 seconds until “ENGLISH INSTALLED” is displayed. If you set the wrong language, follow the
instructions in section ‘Changing and setting menu parameters’, under “Setting the language”.
If your language is not available, select one from those displayed. The instructions refer to the
English version. Then follow the instructions displayed:
3
After 5 seconds, the appliance displays “FILL TANK”. Extract the water tank (fig. 4), rinse and fill
with fresh water without exceeding the MAX line. Replace and push as far as it will go. A water
softener filter can be installed in the tank (fig. 29).
4
Place a cup under the cappuccino maker (fig. 5). The appliance displays: “HOT WATER PRESS OK”.
Press the OK icon (B9) (fig. 3) and after a few seconds a little water comes out of the cappuccino
maker.
5
The machine now displays “TURNING OFF... PLEASE WAIT” and goes off.
6
Extract the appliance by pulling it out using the handles (fig. 6). Open the lid and fill the
container with coffee beans, then close the lid and push the appliance in.
The coffee maker is now ready for normal use.
Important!
Never introduce pre-ground coffee, freeze dried coffee, caramelised beans or anything else which
could damage the appliance.
When using the appliance for the first time, you need to make 4-5 cups of coffee and 4-5
cappuccinos before the appliance gives satisfactory results.
Each time you turn the coffee maker on by the ON/OFF switch (A23), it performs a SELF-
DIAGNOSIS cycle and then goes off. To turn it on again, press the ON/OFF button (A7) (fig. 1)
Using the appliance for the rst time
EN