Filter
Top Products
30
Displayed messages
Displayed message Possible causes What to do
FILL TANK The water tank is empty or
positioned incorrectly.
Fill the tank with water and/or
insert it correctly, pushing it as
far as it will go.
GROUND TOO FINE
ADJUST MILL AND
(alternating with)
PRESS OK
The grinding is too fine and
the coffee is delivered too
slowly.
The machine cannot make
coffee as there is air in the
hydraulic circuit. Possible
cause: the filter has not been
installed correctly.
Turn the grinding
adjustment knob one click
clockwise towards “7”.
Make sure the filter (A26) is
propertly installed and that
the installation has been
carried out correctly.
GROUND TOO FINE
ADJUST MILL AND
(alternating with)
PRESS OK
(then) FILL TANK
The tank has been removed
during delivery.
Insert the tank and press
the OK icon (B9). “HOT
WATER PRESS OK” is displayed.
EMPTY WASTE COFFEE
CONTAINER
The waste coffee container
(
A4) is
too full or more than 3 days have
passed since you last made coffee
(this guarantees correct hygiene
of the machine).
Empty the waste coffee
container and clean, then
replace.
Important!
When removing the drip tray,
the waste coffee container
MUST be emptied, even if
it is not completely full. If this is
not done, when you make the
next coffees, the waste coffee
container may fill up more
than expected and clog the
machine.
INSERT WASTE COFFEE
CONTAINER
After cleaning, the waste coffee
container has not been replaced.
Open the service door and
insert the waste coffee
container.
ADD PRE-GROUND
COFFEE
The “pre-ground coffee”
function has been selected
without placing any pre-
ground coffee in the funnel.
The funnel (A21) is blocked.
Extract the appliance and
place pre-ground coffee in
the funnel.
Empty the funnel with the
help of a knife as described
in the section “Cleaning the
pre-ground coffee funnel”.
EN