Filter
Top Products
6-7
6.7 Replacing the Controller or Controller Wiring Harness
1. Disconnect the fryer from the electrical supply.
2. Remove the two screws in the upper corners of the control panel and swing the panel open from
the top, allowing it to rest on its hinge tabs.
3. Disconnect the wiring harness from the back of the controller and, if replacing the harness,
disconnect it from the interface board (see photo on following page).
4. If replacing the controller, disconnect the ground wire and remove the controller by lifting it
from the hinge slots in the control panel frame.
5. Reverse the procedure to install a new controller or wiring harness.