Filter
Top Products
28 Heat & Glo • VRTIKL-CE • 7031-292 Rev E • 12/07
J. Inner Glass Door Assembly Replacement
I. Front Door Glass Assembly Installation
Figure 8.17 Complete Assembly
Turn the gas stove OFF and let it cool down before replacing
the inner glass door assembly.
With the front door assembly removed from the gas stove,
remove the inner glass door assembly by disengaging the
spring-loaded latches at the bottom of the gas stove and
lifting off of the two spring-loaded latches at the top of the
gas stove.
Replace with a new inner glass door assembly.
Remove the front door assembly by pulling bottom of front
away from gas stove and lifting it off of the hooks on top of
the gas stove (see Figure 8.15).
Refer to Figure 8.16: Position the four fl at 6 mm spacer
washers on the front door so that the four mounting screws
pass through them. Position the glass over the front door.
Install the four protective barrels into the glass and the four
nylon washers on top of the glass.
From inside the door front, pass the screws through to the
outside and thread on the caps until tight.
Cap and Barrel Fastener System
Nylon washer on back
and front of glassScrew
Finishing Cap
Protective barrel sleeve
through hole in the glass
Back side of
front door
Figure 8.16
Figure 8.15
Handle glass assembly with care.
CAUTION
• Inspect the gasket to ensure it is undamaged.
• Inspect the glass for cracks, chips or
scratches.
• Do NOT strike, slam or scratch glass.
• Do NOT operate gas stove with glass door
removed, cracked, broken or scratched.
• Replace glass assembly as a complete
assembly.