Filter
Top Products
Querying the Microwave Switch
This section summarizes the query commands you can use to determine the
configuration or state of the Microwave Switch. All commands end with
the question mark (?) which puts the data into the output buffer where you
can retrieve it to your computer. See Chapter 4 for more information.
Channel Closed:
CLOS?
Channel Opened:
OPEN?
Mainframe TRIG OUT State:
OUTP:STAT?
Module Description:
SYST:CDES?
Module Type:
SYST:CTYP?
Number of Scanning Cycles:
ARM:COUN?
Scanning Mode:
SCAN:MODE?
Scanning State
INIT:CONT?
Status Operation Enable:
STAT:OPER:ENAB?
Status Operation Event:
STAT:OPER:EVEN?
System Error:
SYST:ERR?
Trigger Source:
TRIG:SOUR?
46 Using the HP E1368A/69A/70A Modules Chapter 3