Filter
Top Products
DISPlay
The DISPlay subsystem monitors the channel state of a selected module (or
card) in a switchbox. This subsystem only operates with mainframes that
have a display, such as the HP 75000 Series B Mainframe (HP Model
Number E1301A).
Subsystem Syntax DISPlay
:MONitor
:CARD <
number | AUTO>
[:STATe] <
mode>
[:STATe]?
:MONitor:CARD DISPlay:MONitor:CARD <number | AUTO> selects the module in a
switchbox to be monitored when the monitor mode is enabled. Use the
DISPlay:MONitor:STATe command to enable and disable the monitor mode.
Parameters
Parameter Name Parameter Type Range of Values Default Value
number
|
AUTO
numeric 1 - 99 or AUTO AUTO
Comments • Selecting a Specific Module to be Monitored: Use the
DISPlay:MONitor:CARD command to send the card number in a
switchbox to be monitored.
• Selecting the Present Module to be Monitored: Use the
DISPlay:MONitor AUTO command to select the last module
addressed by a switching command (e.g.,
[ROUTe:]CLOSe).
• *RST Condition: DISPlay:MONitor:CARD AUTO
Example Select Module #2 in a Switchbox for Monitoring
DISP:MON:CARD 2 Selects module #2 in a switchbox
to be monitored when the mode is
enabled.
Chapter 4 HP E1368A/69A/70A Command Reference 53