Filter
Top Products
N
Non-HP Switches, 20
Numeric Command Parameters, 49
O
*OPC, 70
*OPC?, 70
OPEN, ([ROUTe:]OPEN), 14, 29, 59, 71
OPEN?, ([ROUTe:]OPEN?), 46, 60, 71
Opening
channels, 31, 59
Operation Status Register, 41, 62 - 63
OPERation:ENABle, (STATus:OPERation:ENABle),
41, 63, 71
OPERation:ENABle?,
(STATus:OPERation:ENABle?), 46, 63, 71
OPERation[:EVENt]?,
(STATus:OPERation[:EVENt]?), 41, 46, 64, 71
Optional Command Parameters, 49
Optional Commands, 16, 48
OUTPut Subsystem, 57, 71
OUTPut[:STATe], 29 - 30, 57, 71
OUTPut[:STATe]?, 46, 57, 71
P
Parameters, 49
Pin-out, ribbon cable, 33
Pivot Armature, 13
Polling for Errors, 43
Port
connecting to different, 14, 33
Event In, 68
ext trig in, 40
numbers, 34
trig out, 39, 57
Power Supply, 13, 24
Programming the Switches, 14
Q
Query
commands, 46
error queue, 66
monitor mode state, 54
number of scanning cycles, 52
open/closed channels, 59 - 60
scanning mode state, 61
scanning states, 56
the microwave switch, 46
trig out port, 57
trigger sources, 69
R
*RCL, 43, 70
Reader comment sheet, 9
Reading the Registers, 76
Recalling Switch States, 43
Registers, 75 - 78
addressing, 76
channel enable, 75 - 77
definitions, 75
device type, 75
manufacturer ID, 75 - 76
operation status, 41, 62 - 63
reading, 76
standard event status, 43
standard operation status, 62
status, 41, 63
status/control, 75, 77
writing to, 77
Removing Jumpers, 24
Reset
conditions, 30
default values, 30
switchbox, 16
Ribbon Cable
connecting to external device, 35
pin numbers, 33
ROUTe: Subsystem, 58 - 61, 71
ROUTe:CLOSe, 14, 29, 58, 71
ROUTe:CLOSe?, 29, 46, 59, 71
ROUTe:OPEN, 14, 29, 59, 71
ROUTe:OPEN?, 46, 60, 71
ROUTe:SCAN, 29, 60, 71
ROUTe:SCAN:MODE, 30, 61, 71
ROUTe:SCAN:MODE?, 46, 61, 71
ROUTe:SCAN:PORT, 30
Routing Signals, 36 - 38
*RST, 29 - 30, 70 - 71
84 HP E1368A/69A/70A Modules User’s Manual Index