Filter
Top Products
Using the Count-Down Mode (Timed Mixing)
1. Turn the SPEED dial to select a mix speed.
a. If the count-up mode was used for the previous batch, the desired time needs to be
entered.
b. If the count-down mode was used for the previous batch, the previous time will be
displayed. If a different time is needed, turn the TIME selector to the desired time in
10 second increments.
2. Press the START button to begin mixing; the timer starts counting down from the set time.
a. To stop the mixer at any time, press the STOP button. To resume mixing, press the START
button. For example: The mixer is started at SPEED 1 for 30 seconds and is stopped after
10 seconds. Pressing the START button will resume the mixing operation.
b. If the mixer is stopped and a new time setting is entered, pressing the START button
saves the new time setting on the current speed selection.
For example: The mixer is started at SPEED 1 for 30 seconds and is stopped after 10
seconds. A new time is entered by turning the TIME selector. The new time will replace
the initial 30 seconds for SPEED 1 after the START button is pressed.
c. If the time is changed while mixing, the mixer will operate until the new time expires.
The adjustment to the time will not be stored.
d. If speed is changed while mixing, the time will change to the previous time for the
selected speed and count down.
NOTE: If the wire cage is opened at any time, the mixing operation will stop. To
resume the mixing operation, close the wire cage and press the START button.
3. When the timer reaches 00:00, the mixer stops; a beeper sounds for 1 second. The count-
down timer then displays the last-stored time.
O
PERATING NOTES
x STIR is to be used for incorporating ingredients. Do not use it to develop dough
products.
x If the mixer is stopped during a mixing operation, the timer also stops. The timer starts
again (with the time remaining) when the START button is pressed.
x Turn the TIME selector clockwise to take the mixer out of the hold mode.
Fig. 8
10
HL200 Mixer Technical Manual Page 16 of 111