Hoshizaki DCM 300BAH(-OS) Ice Maker User Manual


  Open as PDF
of 55
 
50
9)Inbadorseverewaterconditions,cleantheoatswitchassemblyasdescribedbelow.
Otherwise, continue to step 10.
a.Removetheoatswitchassemblyfromthereservoircover.
b.Wipedowntheoatswitchassemblywiththecleaningsolution.
c.Rinsetheoatswitchassemblythoroughlywithcleanwater.
d.Replacetheoatswitchassemblyinitscorrectposition.
10) Move the power switch to the "ON" position and replace the panels in their correct
positions. Turn on the power supply, then move the control switch to the "ICE" position.
Make ice using the solution until the icemaker stops making ice.
Note: This icemaker will not run if the safety switch is not engaged.
11) Move the control switch to the "DRAIN" position. Allow the water system to drain for
5minutes.
12) Move the control switch to the "ICE" position. Open the icemaker water supply line
shut-off valve to supply water to the reservoir.
13) After the gear motor starts, move the control switch to the "DRAIN" position. Allow the
water system to drain for 5minutes.
Note: If you do not sanitize the icemaker, move the control switch to the "ICE" position
after the water system drains. Allow the icemaker to run for 30 minutes, then
move the control switch to the "OFF" position. Turn off the power supply, then
remove the front panel and storage bin cover. Move the power switch to the "OFF"
position. Go to step 12 in "VI.A.2.c) Cleaning and Sanitizing Procedure" under
"2.DispenseComponents."
14) Move the control switch to the "OFF" position, then turn off the power supply.
15) Close the icemaker water supply line shut-off valve.
c) Sanitizing Solution
Dilute0.82.oz.(25ml)ofa5.25%sodiumhypochloritesolution(chlorinebleach)with
1.6 gal. (6.0 l) of warm water.
d) Sanitizing Procedure - Following Cleaning Procedure
1) Make sure the control switch is in the "OFF" position, the power supply is off, and the
icemaker water supply line shut-off valve is closed.
2) Remove the front and top panels, then move the power switch to the "OFF" position.
3) Remove the storage bin cover. Remove spout B, then remove spout A.
4) Pour the sanitizing solution over the extruding head until the evaporator assembly and
thereservoirarefullandthesolutionstartstooverowintothedrainpan.
5) Replace spout A, spout B, and the storage bin cover in their correct positions.
6) Allow the icemaker to sit for 10 minutes before operation.
7) Move the power switch to the "ON" position and replace the panels in their correct
positions. Turn on the power supply, then move the control switch to the "ICE" position.
Make ice using the solution until the icemaker stops making ice.
8) Move the control switch to the "DRAIN" position. Allow the water system to drain for
5minutes.
 previous next