Filter
Top Products
51
9) Move the control switch to the "ICE" position. Open the icemaker water supply line
shut-off valve to supply water to the reservoir.
10) After the gear motor starts, move the control switch to the "DRAIN" position. Allow the
water system to drain for 5minutes.
11) Move the control switch to the "ICE" position. Allow the icemaker to run for 30 minutes,
then clean and sanitize the dispense components as outlined below.
2. Dispense Components
Perform after cleaning and sanitizing the water system as outlined above.
a) Cleaning Solution
Dilute9.6.oz.(0.29l)ofHoshizaki"ScaleAway"with1.6gal.(6.0l)ofwarmwater.
b) Sanitizing Solution
Dilute0.82.oz.(25ml)ofa5.25%sodiumhypochloritesolution(chlorinebleach)with
1.6 gal. (6.0 l) of warm water.
c) Cleaning and Sanitizing Procedure
1) Move the control switch to the "OFF" position, then turn off the power supply.
2) Remove the front and top panels, then move the power switch to the "OFF" position.
3) Remove the storage bin cover.
4) Remove the motor bracket thumbscrews, rst from the vertical plane and then from
the horizontal plane. While holding on to the corresponding agitator or auger, move
the agitating motor or the dispense motor towards you. Remove the agitator and the
dispense auger from the storage bin. See Fig. 5.
5) Remove the bin control assembly. See Fig. 6.
6) Remove the snap pin, shaft, and actuator.
7) Remove spout B, spout A, and their gaskets.
Spout B
Spout A
Fig. 6
Bin Control
Bracket
Snap Pin
Shaft
Actuator
Bin Control Assembly