Filter
Top Products
TEMPERATURE PROBE MICRO/CONVEC COOKING
Consult the "Temperature Controlled Cooking Guide"
on page 32 before you start Temperature Probe
Micro/Convec Cooking. The following directions show
"One-Stage Cooking" only ....
1. Put in the Temperature Probe
in food, with the first inch of the
Sensor in center of food.
Probe should be in a level
direction or on an angle as
shown.
6. Touch MICRO/CONVEC
TEMP.
Lights below COOK I, above
TEMP and MICRO and
CONVEC will go on and "F"
shows in the display window.
o
Set the desired food tempera-
ture for Temperature Probe by
touching the corresponding
numbers. If 185°F is desired,
for example, touch numbers
"1", "8' and "5". "185F" then
shows in the display window.
C_Z_F_g F-S_
_sw_
2. Plug Temperature Probe into
socket on side of oven.
CAUTION: Do not plug the
Pointed End of the Temperature
Probe into the socket.
°
4.
o
Touch CLEAR.
Touch OVEN TEMP/
PREHEAT.
The light below COOK I will go
on and "F" shows inthe display
window.
Set the oven temperature by
touching the corresponding
numbers.
For example, set 390°F by
touching numbers "3", "9" and
€'0 '_"
"390F" then shows in the
display window.
FTT_
[_E]F-S-I F_7
o Touch START.
The oven is working when the
oven light is on. Lights below
COOK 1, above TEMP and
MICRO and CONVEC will go
on and the food temperature is
shown in the display window.
When the temperature of the
food reaches 185°F while the
oven temperature is program-
med for 390°F, a tone will
sound and the word "End" will
show in the display window for
2 seconds and the cooking is
over.
NOTES: The oven temperature of 350 °F is memorized
in the oven. This means that if the desired oven
temperature is 350°F, you need not touch OVEN
TEMP/PREHEAT or the numbers. Skip steps 4 and 5.
Avoid opening the door during the cooking often since
the hot air will escape from the oven and the oven
temperature drops very quickly, adversely affecting the
cooking results.
*"Preheating" can be set as the directions on page 28.
Follow the instructions numbered 1--4 on page 28, then
follow the instructions beginning with step 4 in this page.
During pause after preheating, place food and plug
temperature probe as shown steps 1 and 2 above, and
then touch START again.
*Use Pot holders to remove the Metal Rack after cooking
as the Rack may get hot during cooking.
*Ceramic tray should always be in the oven for
micro/convec cooking.
33