Kenmore 87561 Convection Oven User Manual


 
INSTALLATION
Install your oven by following these four simple steps:
Step 1: Remove all packing material and accessories. Then remove the protection sheet on wrapper.
Step 2: Place the oven in the level location of your choice, but make sure there is at least one inch of
space on the top and at the rear for proper ventilation. The top of the oven should be kept clear
and the plastic feet must be kept on the oven so there is air flow ventilation. An exhaust outlet
is at the rear of the oven. Blocking the outlet can damage the oven.
Step 3: Plug your oven into a Standard 120 volt household outlet. Be sure the electrical circuit is at least
15 amperes and that your microwave/convection oven is the only appliance on the circuit.
Step 4: When your microwave/convection oven is plugged in for the first time or when power resumes
after a power interruption, the numbers in the display window will show "0:00" plus the hours
and minutes that have elapsed since the oven was plugged in or the power was restored. This
means that the TIME OF DAY clock must be set. Refer to "Setting Time of Day" below.
NOTE: If your oven does not operate properly, unplug the oven from the 120-volt household outlet and
then plug it back in.
This unit is not designed for 50 Hz or any circuit other than a 120 volt/60 Hz AC circuit.
SETTING TIME OF DAY
o Touch CLEAR.
Touch TIME OF DAY.
Touch numbers indicating the correct time.
® Touch TIME OF DAY.
(This is also explained in the "Easy Use Chart" Time of Day Section on Page 11.)
I
DIMENSIONS
IIII
Height
Width
Depth
Weight
14-9/16"
20-1/2"
19-11/16"
53 lbs.
When one side is
installed flush to
the wall, the opposite
side or top must be open.