Filter
Top Products
FREESTANDING iNSTALLATiON
Install base cabinets 301/2" min apart and be sure
they are plumb and level
if the backguard is to be installed, see instructions
on page 3 If ordering a backguard, order kit no
80492 from your Sears catalog
If changing or installing end panels, see instructions
on page 4 If ordering end panels, order kit nos
80351 (white), 80338 (almond) from your Sears
catalog
Adjust leveler legs. so the dimensions from the floor
to the top of the cooktop is the same as the
countertop height (36-)
Slide range into opening
COLt_ TE RTOP
OVE_H At',iG
,".... *,VAL L
I. \ .... _AOh'T OF
CAQINETS
]O MIN TO BOTTOM OF .......
CABINET AOOVE RANG_
]!
T-_
_[t MtI',;" TO IJOTTOt,_ OF
CABtN_ TS O1%,_ITHER SIDE
OF RANGE
i
.._ .L._
B_ET Wf_EN CABtNE15
i
3 WIRE WALL
RECEPTACL_
.... FLOO_
t
BUILT-IN INSTALLATION (Slide-ins)
...........WALL
; BACKGUA_tD t CUTOUT | } BACKGUARD
1 l
OVERHANG CASfNET
3_MI_ _ -_IB MiN TO BOTTOM OF
CABINET ABOVE RANGE CABINETS ON EITHER SiDE
T , •
36
I OFRANGE
_ OETWEEN _l
CABINETS
.10__
{'_" 4'i;f MAX
_- 3 WIRE WALt
_ECEPTACLE
This type of installation requires that the end panels
be removed (if equipped) and two toe protectors,
part no 1325189, be installed (if not equipped) The
toe protectors are listed in the repair parts book and
can be ordered through the Sears Service Center
See instructions on page
The range cooktop overlaps the countertop at the
sides and the range rests on the floor
Install base cabinet 30- apart and be sure they are
plumb and level before attaching countertop
Cutout countertop exactly as shown Note the
countertop cutout dimensions, for installation with
or without backguard
If the backguard is to be installed, see instructions
on page 3 If ordering a backguard order kit no's
80491 or 80492 from your Sears catalog
Remove drawer Adiust leveler legs. so that the
underside of the cooktop is Ys higher than the
height of your countertop
Slide range into opening Adjust leveler legs until
underside of cooktop rests on top of countertop
27