Filter
Top Products
_f
RANGE END PANEL REMOVAL OR INSTALLATION
WARNING - Disconnect electrical power to range before beginning installation
The end panel kit consists of:
Two End Panels (RH & L H,)
Two End Panel Brackets
Eight Screws
Instatlation instruction sheet
MODULAR RANGES
TO REMOVE END PANEL:
1_ Remove both modules from range top
2 From inside of modular opening remove the
screw (circle A)
3 Remove the two screws from the back of end
panel,
4 Move the end panel out at the rear and slide out
from behind the front trim
FOR BUILT-IN INSTALLATION ONLY:
This type of installation requires that the end panels be
removed (if equipped) and two toe protectors, part no
1325189, be installed (if not equipped) The toe
protectors are listed in the repair parts book and can be
ordered through the Sears service center
1 Remove end panels as shown above
2, install toe protectors as shown, using existing
screws on range,
BRACKET ON END PA
FRONT TRIM
INSTALL TOE PROTECTORS . ." ,'
FOR BUILT-IN "_-._, '
INSTALLATION ONLY
TO INSTALL END PANEL:
1_ Attach end panel bracket to end panel with
screw provided
2 Position the end panel behind the front trim
and tight to the underside of the cooktop
frame,
3, Align the two holes in the back of end panel
with holes in range back and attach with
screws provided°
4_ From inside of modular opening, drive a
screw into bracket. (Circle A)
COIL TOP RANGES
TO REMOVE END PANEL:
t Raise cooktop and securely support or have it
held, remove screw B
2 Remove the two screws from the back of end
Panel_
3 Move the end panel out at the rear and slide out
from behind the front trim
FOR BUILT-IN INSTALLATION ONLY:
1 Remove end panels as shown above
2 install toe protectors as shown, using existing
screws on range
FRONT
INSTALL TOE PROTECTORS /.
FOR BUILT_IN __
INSTALLATION ONLY ._'_
TO INSTALL END PANEL:
1, Remove toe protectors and replace mounting
screws,
2 Position the end panel behind the front trim and
tight to the underside of upper side panet,
3o Align the two holes in the back of end panel with
holes in range back and attach with screws
provided
4, Raise cooktop and securely support or have it
held, drive a screw through upper side panel into
end panel,
30