Filter
Top Products
BACKGUARD ATTACHMENT UNSTRUCTUONS
WARNING -- Disconnect electrical power to range before beginning installation
Adjust the width of the backguard to fit inside the countertop cutout,
TO ADJUST WIDTH OF BACKGUARD:
A. Loosen screws holding end caps to back guard supports
B Slide end caps in or out
C, Retighten screws
(Screws A)
TO ATTACH TO RANGE:
FASTEN THE BACKGUARD MOUNTING BRACKETS TO
THE UPPER SIDE PANELS, USING EXISTING SCREWS ON
RANGE, (Screws B)
TO ADJUST THE FRONT TO BACK POSITION OF THE BACKGUARD:
(After attached to range)
A Loosen screws holding backguard to mounting brackets..
B, Position backguard as desired.
C Retighten screws. (Screws C)
REMOVE PROTECTIVE COVERING
FROM BACKGUARD PANEL BEFORE
OPERATING RANGE
TO ADJUST END CAP, LOOSEN
SCREWS A
TO ADJUST BACKGUARD
POSITION, LOOSEN SCREWS C
SCREWS B
MOUNTING BRACKET
29