Filter
Top Products
COiL MODULE REMOVAL AND REPLACEMENT
Make sure all Surface Unit Control Knobs are in l
the "OFF" position and the modules are cool
bbefore removing or replacing.,
To remove or replace Surface Unit Modules
.
,
To remove:
oLift module using the handle at the front (See
Step t) Raise front just high enough to grasp at
front edge
o Ease module toward you using both hands to
unplug it (See Step 2 )
o Lift module out of cooktop All modules may be
used in either cooktop position (_eft or right)
To replace:
°Grasp module with both hands (See Step 2)
• Ease it into place, align the module terminal with
the receptacle on the cooktop (See Step 3.)
= Lower the module, using the handle on the front
(See Step 1 )
/
Receptacle
Terminal
Step 2
modume
Step I
Step 3
SURFACE UNiT REMOVAL FOR CLEANING
CAUTION: Be sure the switch is turned off and the
element is cool before removing elemenL
The surface units can be unplugged and removed for
easier c_eaning of the cooktop
When removing, tilt surface unit upward slightly to clear
reflector bowl and pull away from terminal block Sur-
face unit will not sit level, when replaced, if it is forced
too far upward when removing DO NOT put unit in
water to clean it! It will clean itself when heated during
normal cooking use Lift out the chrome reflector bowis
for cleaning,
Place ciean reflector bowls into cooktop making sure
the terminal block is open and showing Slide surface
unit into terminal block and lower into reflector bowl
CAUTION: Do not attempt to operate surface elements unless reflector bowls are in place Failure to do this will
cause scorching of cooktop, burning of wiring insulation and toss of energy