Filter
Top Products
2-20
REMOVING THE POWER CORD
WARNING
Personal Injury Hazard
Disconnect from the electrical supply be-
fore servicing the unit. Failure to do so
could result in death or electrical shock.
CAUTION: Because of the weight and size of
the microwave oven, two people are required
to safely move and install it. Failure to do so
could result in personal injury.
1. Disconnect the electrical supply to the
microwave oven.
2. Remove the microwave oven from its
mounting location (refer to page 2-2 for
the procedure).
3. Remove the vent grille and the cabinet
from the microwave oven (see page 2-2).
4. Remove the three mounting screws hold-
ing the top of the right side panel to the
plastic cover.
5. Raise the plastic cover just enough to
slide the power cord strain relief block out
of the chassis slot.
6. Unplug the black and white power cord
leads. NOTE: Disconnect the black lead
by pressing in on the locking arm of the
connector and pulling it loose.
7. Remove the ground screw from the green
power cord lead.
8. Remove the old power cord.
9. Raise the cover just enough to slide the
new power cord strain relief block into the
chassis slot, then reconnect the leads
and reassemble the microwave oven.
FAN MOTOR
CONNECTOR
RIGHT
SIDE
PANEL
(3)
TOP RIGHT
SIDE PANEL
SCREWS
POWER
CORD
STRAIN
RELIEF
BLOCK
SLIDE
OVER
CHASSIS
COVER
SCREW
TO LINE
FUSE
WIRING HARNESS
CONNECTOR
WHITE
GREEN
GROUND
SCREW
LINE
FUSE
PLASTIC
COVER
BLACK