Filter
Top Products
2-28
ACCESSING THE HIGH VOLTAGE COMPONENTS
3. Remove the vent grille, the cabinet, and
base plate from the microwave oven (re-
fer to page 2-2 for the procedure).
4. Remove the control panel from the micro-
wave oven, unplug the wire connectors
from the control board, and set the control
panel aside (see page 2-17 for the proce-
dure).
5. Unplug the blower motor cable from its
connector and remove the motor from the
oven.
6. Remove the five screws holding the right
side panel to the oven and pull it away
from the oven.
7. Disconnect the power cord leads and the
base thermal fuse wires (see the illustra-
tion on page 2-19) and set the side panel
aside.
Proceed to the section on the following pages
for the high voltage component you wish to
service.
FAN MOTOR
CONNECTOR
RIGHT
SIDE PANEL
SIDE PANEL
SCREW
PLASTIC
COVER
SIDE PANEL
SCREW
SIDE PANEL
SCREW
SIDE PANEL
SCREWS
WARNING
Personal Injury Hazard
Disconnect from the electrical supply be-
fore servicing the unit. Failure to do so
could result in death or electrical shock.
CAUTION: Because of the weight and size of
the microwave oven, two people are required
to safely move and install it. Failure to do so
could result in personal injury.
To gain access to the high voltage compo-
nents, perform the following steps.
1. Disconnect the electrical supply to the
microwave oven.
2. Remove the microwave oven from its
mounting location.