Filter
Top Products
6 System Guide
System Guide
Inputs and Outputs
The following table describes the system inputs and outputs:
To take full advantage of the high quality serial digital interface (SDI)
capability of your workstation, you should connect the digital devices directly
to the SDI ports on the Intergraph StudioZ card and to the AES/EBU - S/PDIF
output from the Antex card.
Avoid using adapters because they may cause signal degradation. If you must
use them, use only high-quality, tight-fitting adapters.
For detailed instructions on connecting your system, see Connecting the
Hardware on page 7.
Input/Output Description
Video In Serial Digital In (SDI) via BNC connector.
Video Out SDI out via BNC connector.
Composite out via BNC connector.
Y/C via 4-pin mini DIN (this port is used for the software video
interface).
Analog Audio In 4 female XLR connectors. Line input 600 ohms.
Analog Audio Out 4 male XLR connectors. Line output 600 ohms.
Digital Audio In Female XLR connector; AES/EBU or S/PDIF.
Digital Audio Out Male XLR connector; AES/EBU or S/PDIF.
Sync In BNC connector.
RS-232 Remote DB-9 connector.Connects to the Pipeline cable for converting RS-
232 to RS-422. Use only the supplied cable.
Install_ch1.book : Install_ch1.fm Page 6 Tuesday, December 16, 1997 5:57 PM