Filter
Top Products
28 System Guide
System Guide
4. In the Customize dialog box, select PCM in the Format list box.
5. In the Attributes list box, select 44.100 kHz, 16-Bit, Stereo 172 Kb/sec.
6. In the Name list box, click Save As and enter DS Settings.
The audio settings are saved in the DS Settings folder.
To set the Antex mixer
1. On the Windows NT desktop, click Start > Programs > Antex Mixer.
The Antex Mixer dialog box is displayed.
2. Choose Mixer > Lines and select both Adapter, and Digital Out from the
list.
Selecting Digital Out enables MIDI output. Selecting Adapter ensures that
the Sample Clock is displayed when you close the Lines dialog box.
Antex Mixer
3. In the Antex Mixer dialog box, click the Line In button to set the Sample
Clock for the Analog input.
4. In the Sample Clock box select the following analog settings:
•Set Source to Internal
•Set Reference to 27MHz
• Set the Sample Rate to 44100
5. Click the Digital In button to set the Sample Clock for Digital input.
6. In the Sample Clock box, select the following digital settings:
•Set Source to Digital
•Set Reference to Auto
• Set the Sample Rate to 48000 (or 44100)
Note
If a Not Valid message is displayed over the Digital In box, it
means that the Antex digital I/O cable is not receiving a valid
digital signal and you should verify the audio connections.
Install_ch1.book : Install_ch1.fm Page 28 Tuesday, December 16, 1997 5:57 PM