Filter
Top Products
10
MAX ICE FEATURE
T
he Max Icefeature increases the rate of ice pro-
duction for times where you need more than
n
ormal. Theincreased iceproduction will last for
24 hours, at which time it will return to the
normal production level. You can expect about a
40% increase in iceproduction when this feature
is turned on.
To initiate the Max Ice feature, press the key
pad on the Control Center so that the indi-
cator is visible in the displaypanel. Refer to the
illustration below.
To turn off the Max Ice feature, simply press the
key pad and the unitwill returntonormal
ice production.
ICE MAKER OPERATION
The ice maker in your Sub-Zero freezer is fully
a
utomatic and has been tested at the factory. To
start making ice, activate the key pad on the
Control Center.
The ice maker system will not shut offif the ice
bucket is notin place.
When removing the ice bucket for an extended
period, deactivate the ice maker by depressing
t
he key pad on the Control Center.
ICE PRODUCTION
The ice maker is designed to produce enough ice
for normalfamily use.The timing of ice-making
cycles will vary depending onload conditions,
door openings and room temperature. On
average, you can expect a cycle of ice (eight
cubes per cycle) every two hours.
The ice maker operates on water pressure of 2.1
bar to 6.9bar. In some cases, a reverse osmosis
water filter systemmay not be able to maintain
the minimum pressure.
IMPORTANT NOTE:
If ice is notused regularly it
tends to fusetogether. To avoid this, empty and
replace the ice in thecontainer as needed.
SUB-ZERO BUILT-IN USE & CARE
Max Ice
Key Pad
Max Ice keypad
AIR PURIFICATION SYSTEM
All Sub-Zero Built-In models (except Model
I
CBBI-36F) include an advanced air purification
system. This system reduces bacteria, odors,
and even ethylene gas, which causes premature
ripening in fruits and vegetables.The air purifi-
cation cartridge has been factory installed andis
located inside the refrigerator, on the right-hand
side of the back wall.
T
he air purification cartridge willlast for approxi-
mately oneyear. The indicator will flash in
the Control Center display panel when it needs
to be replaced. To replace the cartridge, grab the
outside cover from thebottom and pull it for-
ward. It willflip up and expose another flap and
the cartridge. Refer to the illustration below. Pull
the flap forward from the top, which willcause
the cartridge to pop out of position. Remove the
cartridge.
To replace, put the new cartridge into place, with
the connector pointing down. Once in place,
close the flap until you hear a click. Then flip
down the outside cover until it closes against the
wall.
Once the air purificationcartridge hasbeen
replaced, press the keypad on the Control
Center for5 seconds. This will reset the air purifi-
cation indicator and will no longer be displayed.
Air purification cartridge
REPLACEMENT CARTRIDGES
R
eplacementair purification cartridges can be
ordered bycontacting your Sub Zero dealer.
IMPORTANT NOTE:
The warranty for theair
purification cartridge supplied with the unit only
covers defects in materials or workmanshipand
not replacement due tonormal use.
ACCESSORIES
Optional acces-
soriesare available
through your
Sub-Zero dealer. To
obtainlocal dealer
information, visit
our website,
subzero.com.
CAUTION
LAMP CONTAINS MERCURY
Manage in accordance with disposal
laws.