Filter
Top Products
14
LIGHTING INFORMATION
IMPORTANT NOTE:
When the refrigerator or
f
reezer doors are left open for a long time, the
lights maygooff. This protects the internal parts
from overheating. To reset the light system,
close the door for 15 to 30 minutes.
Your Sub-Zero Built-In unit contains unique 40
w
att appliance bulbs (7009935) inrefrigerator
and freezer sections.
I
MPORTANT NOTE:
T
o replace a light bulb, dis-
connect power supply from the receptaclebefore
changing light bulb. The power cord is locatedin
the far right corner behind the flip-up grille.
SUB-ZERO BUILT-IN USE & CARE
Overhead light shieldremoval
OVERHEAD LIGHTING
Y
ou’ll need toremove the light shield inthe top
of the refrigerator orfreezer to replace the bulbs.
P
lace your hands under thelight shield and slide
back slowly until the key slots on thesides of the
light shield drop past the mounting studs in the
upper brackets. Then remove theshield. The
bulbs are nowaccessible. Refer tothe illustration
b
elow.
Models ICBBI-36RG, ICBBI-30UG and
ICBBI-36UG:
Like all Sub-Zero units, lights in
glass doormodels willfully illuminate whenthe
door is open. With theICBBI-36RG,ICBBI-30UG
and ICBBI-36UG, however, you havethe option
of having subdued lighting even with the door
closed. You can easily turn this feature off by
depressingthe key pad onthe Control
Center. The indicator willappear when
accent lights are enabled.
CRISPER LIGHTING
C
risper drawer lighting is located behind the
upper crisper drawer and mounted to the back
w
all of the refrigerator. To remove the light
shield first removethe crisperdrawer. Next
remove theupper crisper shelf.Then place both
hands under the bottom right andleft sides of
the light shield and push upward.
S
ee illustration below.
FREEZER LIGHTING
Models ICBBI-30U, ICBBI-30UG, ICBBI-36U
and ICBBI-36UG:
Freezer lighting is located in
upper front sectionofthe freezercompartment.
To remove the light shield, gently compress the
shield to release it from the supporting guides.
Models ICBBI-42S and ICBBI-48S:
Freezer
basket lighting is located abovethe ice bucket.
To access the bulbs, remove the icebucket. Next,
push the ice bucket assembly to the back ofthe
unit. Oncethe assembly is against the back wall
of the unit, the bulb will be accessible under the
fixed shelf in frontofthe icemaker.
Models ICBBI-42SD and ICBBI-48SD:
Freezer
l
ighting above the ice bucket is accessible by
removing the ice bucket. See Ice Bucket
Removal, page9.Once the bucket has been
removed, remove the light shield. See Overhead
Lighting, page 14.
F
reezer lighting below the Icebucket is acces-
sible by removing the glass light shield. To
r
emove the glass, press the plastic lip up and
pull the glass out of thesupporting guides.
Freezer basket lighting is located below the fixed
shelf on the back wall ofthe freezer.To access
the light first removethe freezerbasket below
the fixed shelf. To remove the light shield, gently
compress theshield to release it from the sup-
porting guides.
Light shield removal—crisper
ACCESSORIES
Optional acces-
soriesare available
through your
Sub-Zero dealer. To
obtainlocal dealer
information, visit
our website,
subzero.com.
Disconnectpower supply from the receptacle
before changing light bulb. Wear protective
gloves when handling bulbs.
CAUTION