Filter
Top Products
9
Over-and-under models:
First, unload the
f
reezer baskets. To remove the upper freezer
basket, lift up on the front and pull forward to
release the basket.To remove thelower freezer
basket, lift the basket directly upward and out.
Refer to the illustrationbelow.
T
o reinstall the lower freezer basket, insert the
basket into the four corner retainers. To reinstall
t
he upper freezer basket, position the basket
onto the slide rails. Slide the basket towards the
back. You should hearanaudible click when the
engagementismade.
IMPORTANT NOTE:
Unload the freezer baskets
before removing.
FREEZER STORAGE
FREEZER BASKET REMOVAL
A
ll freezer and side-by-side models:
F
irst,
unload the freezer basket. To remove the basket,
p
ull it out until it stops. Behind the bottom two
corners ofthe front face of the basket are metal
clips. Pull these clips toward the front of the
basket andlift and rotate the basket up.
IMPORTANT NOTE:
To remove the basketsfrom
Models ICBBI-36S, ICBBI-42S orICBBI-42SD, the
basket must be raised and pulled through the
opening in the door liner after disengaging the
basket from the slides.
IMPORTANT NOTE:
If Models ICBBI-36F or
ICBBI-36S are limited toa 90°opening, itmay be
necessary toremove the basket and/or shelf
above in order to remove the basket.
To reinstall, push the drawer slides back into the
freezer. Alignthe basket with the slides, and
push the basket straight back ontothe slides
until it stops. Press downward on the front of the
basket to engage the basket clips with the slides.
Models ICBBI-42SD and ICBBI-48SD:
To
r
emove the icebucket, pull the bucket out part of
the way, then rotate theright side of thebucket
as you continue to pull the bucketout. Refer to
the illustration below.
ICE BUCKET REMOVAL
O
ver-and-under models and Model ICBBI-36F:
To remove the ice bucket, pull the freezerdrawer
o
r basket out until it stops and lift the icebucket
out.
Models ICBBI-36S, ICBBI-42S and ICBBI-48S:
T
o remove the ice bucket, pull the bucket for-
ward untilitstops. Next, lift thebucket to clear
the carrier assembly along the back edge ofthe
bucket. Once the bucket has cleared the
assembly, continue to pullforward andout. If the
door is limited to a 90° opening, repeat the pro-
cedure, but when lifting the icebucket out,pivot
the right side of the bucket toward you and out.
This will allow the ice bucket to clear the door.
Refer to the illustrationbelow.
Freezer basket removal—allfreezer
and side-by-side models
Freezer basket removal—
over-and-under models
Ice bucket removal—Models
ICBBI-36S,ICBBI-42Sand ICBBI-48S
Ice bucket removal—Models
ICBBI-42SDand ICBBI-48SD
SUB-ZERO BUILT-IN USE & CARE