Filter
Top Products
6
Model C707Safety
130304
S DO NOT allow untrained personnel to
operate this machine.
S DO NOT oper ate the freezer unless all
service panels and access doors are
restrained with screws.
S DO NOT r emove any internal operating
parts ( examples: freezer door, beater,
scraper blades , etc.) unless all control
switches are in the OFF position.
Failure tofollow these instructions may result in severe
personal injury to fingers or hands from hazardous
moving parts.
This unit has many sharp edges that can
cause severe injuries.
S DO NOT put objects or fingers i n the door
spout. This may contaminate the product
and cause severe per sonal injury from blade
contact.
S USE EXTREME CAUTION when removing
the beater asssembly. The scraper blades
are very sharp.
S CAUTION-SHARP EDGES: Two people
are required to handle the cup/cone
dispenser. Protective gloves must be worn
and t he mounting holes must NOT be used
to lift or hold the dispenser. Failure to follow
this instruction can result in personal injur y
to fingers o r equipment damage.
Access to the service area of the unit is
restricted to persons having k nowledge and practical
experience with the appliance, in particular as far as
safety and hygiene are concerned.
This freezer must be placed on a level
surface. F ailure to comply may result in personal injury
or equipment damage.
Cleaning and sanitizing schedules are
governed by your state or local regulatory agencies
and must be followed accordingly. Please refer to the
cleaning section of this manual for the proper
procedure to clean this unit.
This machine is designed to maintain product
temperature under 41_F(5_C). Any product being
added to this machine must be below 41_F(5_C).
Failure to follow this instruction may result in health
hazards and poor freezer performance.
DO NOT obs truct air intake and discharge openings:
The Model C707 air cooled unit requires a minimum of
6” (152 mm) of clearance o n both sides and 0” in the
rear of the unit. This will allow for adequate air flow
across the condenser(s). Failure to allow adequate
clearance can reduce the refrigeration capacity of the
freezer and possibly cause permanent damage to the
compressor.
For Indoor UseOnly: This unit is designed to operate
indoors, under nor mal ambient temperatures of 70 _ -
75_F(21_ -24_C). The freezer has successfully
performed in high a mbient temperatures of
104_(40_C) at reduced capacities.
DO NOT run the machine without product. Failure to
follow this instruction can result in damage to the
machine.
NOISE L EVEL: Airborne noise emission does not
exceed 78 dB(A) when measured at a distance of 1.0
meter from the surface of the machine and at a height
of 1.6 meters from the floor .