Filter
Top Products
4
Model C707To the Operator
131122
Section 2 To the Operator
The Model C707 has been carefully engineered and
manufactured t o give you dependable operation.
This unit, when properly operated and cared for, will
produce a consistent quality product. Lik e all
mechanical p roducts, it will require cleaning and
maintenance. A minimum amount of care and
attention i s necessary if the operating procedures
outlined in this manual are followed closely.
This Operator’s Manual should be read before
operating or performing any maintenance on your
equipment.
Your Taylor freezer will NOT eventually compensate
for and correct any errors during the set- up or filling
operations. Thus, the initial assembly and priming
procedures are of extreme importance. It is strongly
recommended that personnel responsible for the
equipment’ s operation, both assembly and
disassembly, go t hrough these procedures together in
order to be properly trained and to make sure that no
confusion exists.
In the event you should r equire technical assistance,
please contact your local authorized Taylor Distributor.
Note: Your Taylor war ranty is valid only if the parts are
authorized Taylor parts, purchased from the local
authorized Taylor Distributor, and only if all required
service work is p rovided by an authorized Taylor
service technician. Taylor reserves the right to deny
warranty c laims on units or par ts if non- Taylor
approved parts or incorrect refrigerant were installed
in the unit, system modifications were performed
beyond factory recommendations, or it is determined
that the failure was c aused by abuse, misuse, neglect,
or failure to follow all operating instructions. For full
details of your Taylor Warranty, pleas e see the Limited
W arranty section in this manual.
If the crossed out wheeled bin symbol is
affixed to this product, it signifies that this product is
compliant with the EU Directive as well as other similar
legislation in effect after August 13, 2005. T herefore,
it must be collected separately after its use is
completed, and cannot be dis posed as unsorted
municipal waste.
The u ser is responsible for returning the product to the
appropriate collection facility, as specified by y our loc al
code. For additional information regarding applicable
local laws, please contact the municipal facility and/or
local distributor.
Compressor Warranty Disclaimer
The refrigeration compressor(s) o n this unit are
warranted for the t erm stated in the Limited Warranty
section in this manual. H owever, due to the M ontreal
Protocol and the U.S. Clean Air Act Amendments of
1990, many new refrigerants are being tested and
developed, thus seeking their way into the service
industry. Some of these new refrigerants are being
advertised as drop- in replacements for numerous
applications. It should be noted that in the event of
ordinary service t o this unit’s refrigeration system,
only the refrigerant specified on the affixed data
label should be used. The unauthorized use of
alternate refrigerants will void your Taylor compressor
warranty. It is the unit owner’s responsibility to make
this fact known to any technician he employs.
It s hould also be noted that Taylor doesnot warrant the
refrigerant used in its equipment. For example, if the
refrigerant is lost during the course of ordinary service
to this machine, Taylor has no obligation to either
supply or provide its replacement either at billable or
unbillable terms. Taylor does have the obligation to
recommend a suitable replacement if the o riginal
refrigerant is banned, obsoleted, or no longer available
during the five y ear warranty of the compressor.
Taylor will continue to monitor the industry and test
new alternates as they are being developed. Should a
new alternate prove, through our testing, that it would
be accepted as a drop- in replacement, then the above
disclaimer would bec ome null and void. To find out the
current status of an alternate refrigerant as it relates to
your compressor warranty, call the local Taylor
Distributor or the Taylor Factory. Be p repared to
provide the Model/Serial Number of the unit in
question.