Filter
Top Products
1
Model C707 To the Instal ler
131122
Section 1 To the Installer
The following information has been included in the
manual as safety and regulatory guidelines. For
complete installation instructions, please see the
Installation Checklist.
Installer Safety
In all areas of the w orld, equipm ent should be
installed i n accordance with e xisting local codes.
Please contact your local authorities if you have any
questions.
Care should b e taken to ensure that all basic safety
practices a re followed during the installation and
servicing activities related to the installation and
service of Taylor equipm ent.
S Only authorized Taylor service personnel
should perform installation and repairs on
the equipment.
S Authorized service per sonnel should consult
OSHA Standard 29CFRI910.147 or the
applicable code of the local area for the
industry standards on lockout/tagout
procedures before beginning any installation
or repairs.
S Authorized service per sonnel must ensure
that the proper PPE is available and worn
when required during installation and
service.
S Authorized service per sonnel must remove
all metal jewelr y, rings, and watches before
working o n electrical equipment.
The main power supply(s) to the freezer must
be disconnected prior to performing any repairs.
Failure to follow this instruction may result in personal
injury or death from electrical shock or hazardous
moving parts as well as poor performance or damage
to the equipment.
Note:Allrepairsmustbeperformedbyan
authorized Taylor Service Technician.
This unit has many sharp edges that can
cause severe injuries.
Site Preparation
Review the area where the unit will be ins talled before
uncrating the unit. Make sure all possible hazards to
the u ser or equipment have been addressed.
Air Cooled Units
DO NOT obs truct air intake and discharge openings:
The Model C707 air cooled unit requires a minimum of
6” (152 mm) of clearance o n both sides and 0” in the
rear of the unit. This will allow for adequate air flow
across the condenser(s). Failure to allow adequate
clearance can reduce the refrigeration capacity of the
freezer and possibly cause permanent damage to the
compressor.
For Indoor Use Only: This unit is designed to operate
indoors, under normal ambient t emperatures of
70_-75_F(21_-24_C). The freezer has successfully
performed in high a mbient temperatures of
104_(40_C) at reduced capacities.
This unit must NOT be installed in an area
where a water jet or hose can be used. NEVER use a
water jet or hose to rinse or clean the unit. Failure to
follow this instruction m ay result in electrocution.
This unit must be installed on a level surface
to avoid the hazard of tipping. Extreme care should be
taken in moving this equipment for any reason. Two or
more persons are required to safely move this unit.
Failure to comply may result in personal injury or
equipment damage.
Uncrate t he unit and inspect it for damage. Report any
damage to your Taylor Dis tributor.
This piece of equipment is made in t he USA and has
USA sizes of hardware. All metric conversions are
approximate and vary in size.