Filter
Top Products
26
Model C707Troubleshooting Guide
PROBLEM PROBABLE CAUSE REMEDY PAGE
REF.
6. The drive s haft i s stuck in
the d rive coupling.
a. Rounded corners o f drive
shaft, coupling, or both.
a. Call service technician to
correct cause, and to
replace the necessary
components. Do not
lubricate the hex end of
the drive shaft.
---
b. Mix and lubricant collected
in t he drive coupling.
b. Brush clean the rear shell
bearing area regularly.
22
7. The freezing cylinder walls
are scored.
a. The beater assembly is
bent.
a. Call service technician to
repair or replace the
beater and to correct the
cause of insufficient mix i n
the freezing c ylinder.
---
b. The front bear ing is
missing or worn on the
freezer door.
b. Install or replace the front
bearing.
15
8. Excessive mix leakage
into the rear dr ip pan.
a. Missing or worn drive
shaft seal on drive shaft.
a. Install or replace regularly.
14 / 27
b. The rear shell bearing is
worn.
b. Call service technician to
replace rear shell bearing.
---
9. Excessive mix leakage
from door spout.
a. Missing or worn draw
valve o- rings.
a. Install or replace regularly.
16 / 27
b. Inadequate lubrication o f
draw valve o- rings.
b. Lubricate properly.
16
c. W rong type of lubricant is
being used (example:
petroleum bas e lubricant).
c. Use the proper lubricant
(example: Taylor Lube).
14
10. No freezer operation after
pressing the AUT O key.
a. Unit is unplugged. a. Plug into wall receptacle.
---
b. The c ircuit breaker is off
or the fuse is blown.
b. Turn the b reaker on, or
replace the fuse.
---
c. The beater motor i s out on
reset.
c. Reset the freezer .
12
11 . Product is not feeding into
the freezing c ylinder.
a. Inadequate level of mix i n
the mix hopper.
a. Fill the mix hopper with
mix.
20
b. The m ix inlet hole is
frozen up.
b. The mix hopper
temperature needs
adjustment. Call service
technician.
---