Filter
Top Products
25
Model C707 Troubleshooting Guide
Section 8 Troubleshooting Guide
PROBLEM PROBABLE CAUSE REMEDY PAGE
REF.
1. No product is being
dispensed with draw valve
open and the machine in
the AUT O mode.
a. Freeze- up in mix inlet
hole.
a. Call service technician to
adjust the mix hopper
temperature.
---
b. Beater motor out on reset. b. Reset the freezer .
12
c. The beater is rotating
counterclockwise from the
operator end.
c. Contact service technician
to correct rotation to
clockwise from operator
end.
---
d. The c ircuit breaker is off
or the fuse is blown.
d. Turn the b reaker on, or
replace the fuse.
---
e. There is inadequate mix in
the mix hopper.
e. Fill the mix hopper with
mix.
20
2. The product is too stiff. a. The v iscosity needs
adjustment.
a. Contact service
technician.
---
3. The product is too s oft. a. Viscosity needs
adjustment.
a. Contact service
technician.
---
b. Not enough air space
around unit. (Air cooled
units)
b. Allow f or adequate air flow
across the condenser.
1/ 6
c. W orn scraper blades. c. Replace regularly.
27
d. Dirty condenser (A/C) d. Clean monthly.
24
e. Mix i s out of date. e. Use only fresh mix.
---
f. Loss of water. (W/C) f. Locate c ause of water
loss and correct.
24
4. The mix in the m ix hopper
is too cold.
a. The temperature is out of
adjustment.
a. Call service technician to
adjust the mix hopper
temperature.
---
5. The mix in the m ix hopper
is too warm.
a. The temperature is out of
adjustment.
a. Call service technician to
adjust the mix hopper
temperature.
---
b. The mix hopper cover is
not in position.
b. Place the cover in
position.
20
c. The MIX REF light is not
lit.
c. Press the MIX REF k ey.
11