Filter
Top Products
13
Model C707 Important: To the Operator
130709
Feed Tube Assembly
The feed tube assembly serves two purposes. One
end of the tube has a hole and the other end does not.
Figure 4
ITEM DESCRIPTION PART NO.
1 ORIFICE 022465- 100
2 O- RING- 3/8 OD X .070 W 016137
3 TUBE A.- FEED- SS 5/32 HOLE X29429- 2
4 O- RING- .643 OD X .077 W 018572
1. Normal Operation
During nor mal operation, the end of the feed tube
with the hole is placed into the mix inlet hole.
Every time the drawhandle is raised, newmixand
air from the hopper flow into the freezing cylinder.
This keeps t he freezing cylinder properly loaded
and maintains overrun.
Figure 5
2. Long “No Sale” Periods
During long “No Sale” periods, the unit can be
placed into the Standby mode. This maintains
product temperatures below40_F(4.4_C) inboth
the hopper and the freezing cylinder , and helps
prevent overbeating and product b reakdown.
To placethe unit into theStandby mode, press the
STANDBY key. Remove the air orifice. Lubricate
the o- rings located on the end of the feed tube
without the hole. Place that end of the tube into
the mix inlet hole. This will prevent any mix from
entering the freezing cylinder.
Figure 6
IMPORTANT: Make sure the level of mix in the
hopper is below the mix delivery hole in the
feed tube. Failure to follow this instruction may
result in lower product quality when normal
operation is resumed.
Note: The air orifice is used to meter a certain
amount of air into the freezing cylinder. The air
orifice maintains overrun and allows enough mix
to enter t he freezing cylinder after a draw.