Filter
Top Products
12
Model C707Important: To the Operator
130709
When the STANDBY key is pressed, the light comes
on, indicating the C TR (Cylinder Temperature
Retention System) has been activated. In the
STANDBY mode, the W ASH and AUTO functions are
automatically cancelled. The MIX REF function is
automatically locked in to maintain the mix in the
hopper.
To resume normal operation, press the AUTO key.
When the unit cycles off, the product in the freezing
cylinder will be at serving viscosity. At t his time, place
the feed tube (end with the hole) into the mix inlet
hole and install the air orifice.
Figure 2
WASH Key
When the WASH key is pressed, the light comes on.
This indicates beater motor operation. The S TANDBY
or A UT O modes m ust be cancelled first to ac tivate the
W ASH mode.
AUTO Key
When the AUTO key is pressed, the light comes on.
This indicates that the main refrigeration system has
been activated. In the AUTO mode, the WASH or
STANDBY functions are automatically cancelled. The
MIX REF function is automatically locked in to
maintain the mix in the mix hopper .
Note: An indicating light and an audible tone will
sound whenever a mode of oper ation has been
pressed. To cancel any function, press the key again.
The light and mode of operation will shut of f.
Beater Motor Reset Button
The reset button is located on the left s ide of the unit.
The reset protects the beater motor from an overload
condition. If an overload occurs, the reset mechanism
will trip. To properly reset the freezer, p ress the AUTO
key to cancel the cycle. Turn the power switch to the
OFF position. Press the reset button firmly.
Do not u se metal objects to press the reset
button. Failure to follow this instruction may
result in electrocution.
T urn the power switch to the ON position. Press the
W ASH key and observe the freezer’s performance.
Open the side access panel. Make sure the beater
motor is turning the drive shaft i n a clockwise d irection
(from the operator end) without binding.
If the beater motor is turning properly, press the WASH
key to cancel thecycle. Press theAUTO key toresume
normal operation. If the freezer shuts down again,
contact a service technician.
Adjustable Draw Handle
The Model C707 features an adjustable draw handle
to provide the best portion control. The draw handle
should be adjus ted to p rovide a flow rate of 5 to 7- 1/2
oz. of product per 10 seconds. To INCREASE the flow
rate, turn the screw CLOCKWISE. Turn the screw
COUNTER- CLOCKWISE to DECREASE the flow
rate.
Figure 3