Filter
Top Products
iv
PRECAUTIONS TO BE OBSERVED BEFORE
AND DURING
SERVICING TO AVOID POSSIBLE EXPOSURE
TO EXCESSIVE MICROWAVE ENERGY
1. DO NOT operate or allow the oven to be operated with the door open.
2. Make the following safety checks on all ovens to be serviced before activating the magnetron or other
microwave source, and make repairs as necessary:
a) Interlock operation.
b) Proper door closing.
c) Seal and sealing surfaces (arcing, wear, and other damage).
d) Damage to or loosening of hinges and latches.
e) Evidence of dropping or abuse.
3. Before turning on microwave power for any service test or inspection within the microwave generating
compartments, check the magnetron, wave guide, or transmission line, and cavity for proper alignment,
integrity, and connection.
4. If the oven is operative prior to servicing, a microwave emission check should be performed prior to
servicing the oven. Refer to page 6-2 of this manual for microwave leakage testing procedure.
5. Any defective or mis–aligned components in the interlock, monitor, door seal, and microwave
generation and transmission systems shall be repaired, replaced, or adjusted by procedures described
in this manual before the oven is released to the owner.
6. A microwave leakage check to verify compliance with the Federal Performance Standard MUST BE
performed on each oven prior to release to the owner. Refer to page 6-2 of this manual for microwave
leakage testing procedure.
SAVE THESE INSTRUCTIONS