Filter
Top Products
14
User’s Manual
LEVELING THE UNIT
It is extremely important that the unit is level. If it is not
level, the water will not flow over the ice mold evenly. This
can cause a reduction in ice rate, uneven sized cubes or
water spilling into the storage area which will cause the ice
in the bin to melt prematurely. Remember that floors near
drains have a tendency to slope towards the drain.
1. Use a level to check the levelness of the ice maker from front to
back and from side to side for free-standing installation (Figure 9).
Use a level to check the levelness of the icemaker from front to
back and from side to side by placing a level on the inside edge and
along the door seal edge for built-in installation (Figure 10).
Figure 9 Figure 10
(Free-Standing Installation) (Built-In Installation)
CLRCO029
FRONT SIDE
CLRCO006
30005_CLRCO2075 User Manual 8/22/03 4:24 PM Page 14