Filter
Top Products
21
Install the insert as follows:
1. Remove top hinge screw pin
(7/64" Allen wrench, Figure 24).
Remove door by tilting forward
and lifting off bottom hinge pin.
2. Pull door gasket out of groove
(top edge of door only). Start in
the middle and pull outward, mov-
ing toward the edge (Figure 25).
This may take some force. Do not
remove the three screws behind
gasket.
3. Remove two outside screws
holding door handle. Slightly sep-
arate door handle from door
(Figure 26).
4. Pull handle up and off. Remove
outer door panel and cardboard
spacer.
5. Slide custom door panel insert into
1/4 inch channel in door front.
6. Holding door gasket out of the
way, replace handle on door
making sure it is seated properly
on insert and that screw holes
line up.
7. Install two small screws removed
in step 3.
8. Starting at the corners and
working inward, push door gasket
into place on door.
9. Place door on bottom hinge pin
and install upper hinge screw.
Figure 26
UL310
UL132
DWR020
Figure 25
Figure 24
Insert edges may be
SHARP! Use care when
installing.
!
WARNING
30005_CLRCO2075 User Manual 8/22/03 4:24 PM Page 21