Filter
Top Products
50
CARING FOR YOUR RANGE
Removing the oven door
For normal use of your oven, you do not
need to remove the door. However, if you
have to remove the door follow the instruc-
tions in this section.
The oven door is heavy. Use both hands
to remove and replace the door. Do not lift
and carry the door by the handle. To
remove and replace the door you may need
help.
To remove:
1. Open door all the way.
NOTE: Two
5
⁄32" Allen wrenches or 2 nails
of similar diameter may be used if factory
furnished door removal pins have been
misplaced. Be careful not to damage
porcelain finish.
2. Insert small end of a door removal pin
into each door hinge.
3. Grasp under handle and gently close
door as far as it will shut. Pull door out
at bottom to remove.
4. Set door aside on protected surface.
To replace:
1. Fit hinge arms into slots in frame. Push
in at lower corners to ensure that hinge
arms are fully engaged.
2. Open the door all the way.
3. Remove the door removal pins from
each hole.
4. Close the door.
NOTE: If the door does not operate freely,
you have not installed it properly. Repeat
Steps 1-4.
Insert small end
of pin here
3191537v08c75 9/1/98 2:35 PM Page 50