Filter
Top Products
5
INSTALLATION REQUIREMENTS
IMPORTANT NOTE:
Save these Installation
Instructions for the local inspector’s use.
Please read the entire Installation
I
nstructions prior to installation.
This installation must be completed by a
qualified technician.
Installer:
please retain these instructions
for local inspector’s reference, then leave
them with the homeowner.
Homeowner:
please read and keep
these instructions for future reference and
be sure to read the entire Use & Care
Information prior to use.
IMPORTANT NOTE:
This appliance must be
installed in accordance with local codes. The
correct voltage, frequency and amperage
must be supplied to the appliance from a
dedicated, grounded circuit which is protected
by a properly sized circuit breaker or time
delay fuse. The proper voltage, frequency,
and amperage ratings are listed on the
product rating plate.
Record the model and serial numbers before
installing the fryer module. Both numbers are
listed on the product rating plate located on
the underside of the module. Refer to the
illustration below.
BEFORE YOU START
IMPORTANT NOTE:
Installation and service
must be performed by a qualified installer or
s
ervice agency.
I
nstallation of the fryer module must meet
the minimum clearance requirements for
safe operation. Refer to Site Preparation on
p
age 6.
The fryer module must be installed in a
base cabinet that allows access to the
manual drain valve for draining the oil.
Refer to the Manual Drain Outlet section
on page 8.
If the fryer module is to be used with any
combination of additional cooktop units or
modules, refer to the Multiple Cooktop
Installation section on page 8.
Electrical installation must be adequate
and in compliance with all local codes and
ordinances. Electrical ground is required,
refer to Electrical Requirements on page 10.
IMPORTANT NOTE:
A ventilation hood is
recommended (but not required) for use with
the Wolf electric fryer module.
This module is intended for indoor use.
WOLF FRYER MODULE
M
odel ICBIF15/S
Model Number
ICBIF15/S
Serial Number
Rating plate location
Location of rating
plate under module