Wolf Appliance Company DF484CG Range User Manual


 
44
WOLF DUAL FUEL RANGE CARE
CLEANING THE RANGE
EXTERIOR CLEANING
C
leaning the classic stainless steel exterior
finish:
Use a soft, nonabrasive stainless steel
cleaner like Signature Polish (see side note)
a
nd apply with a soft, lint-free cloth. To bring
out the natural luster, lightly wipe the surface
with a water-dampened microfiber cloth,
followed with a dry microfiber cloth. All work
should follow the grain direction of the finish.
Better results are obtained by keeping the
cloth in continuous contact with the metal.
Refer to Care Recommendations on the follow-
ing pages for cleaning specific components of
the dual fuel range.
RANGE CLEANING TIPS
Wait until surfaces are cool before cleaning.
For best results, wipe up spills and spatters
as they occur and immediately after the
range has cooled. If splatters are allowed to
cook on, they may permanently damage or
stain the finish.
If in doubt about using one of your
cleaners, check the label. To check if it is
safe to use on your range, try a small
amount on an inconspicuous area using
very light pressure.
Use caution when spraying cleaners. Some
contain caustic ingredients that can damage
adjacent par
ts and finishes. Protect the
adjacent parts by masking them of
f so that
the overspray is contained to the finish
being cleaned.
Do not spray cleaners on electrical controls,
igniters, wires or knob valve stems.
SIGNATURE
POLISH
Signature Polish
is available from
Signature Limited
Laboratory,
P.O. Box 13436,
Dayton, Ohio
45413-0436, or
call 877-376-5474
(toll free).
T
urn off electrical power to the oven
before replacing light bulb.
OVEN LIGHT BULB REPLACEMENT
IMPORTANT NOTE:
Allow the oven to cool
sufficiently before replacing the light bulb.
The oven uses a 20-watt halogen light bulb;
replacement part #803816.
To remove the oven light bulb,
remove the
oven rack guides as described on page 23.
Place a hot pad against the oven wall. Using a
flat-head screwdriver, press the screwdriver
against the hot pad and under the edge of the
light cover. Be careful not to scratch the porce-
lain oven interior. Twisting the screwdriver,
gently pry the edge of the light cover up away
from the wall and remove. Use a paper towel
to handle the light bulb and remove it from the
socket.
To replace the oven light bulb,
avoid direct
contact with the replacement bulb. Use a paper
towel to handle the new light bulb to keep oil
on fingers from touching the bulb. Failure to
do this will cause the bulb to burn out at first
use. Insert the light bulb prongs into the socket
until it snaps into place. Replace the light cover
and oven rack guides. Turn on electrical power
and reset the time-of-day clock.