Wolf Appliance Company DF484CG Range User Manual


 
5
TOP SURFACE BURNERS
Have your installer show you where
the gas supply shut-off valve is
located in your home. Learn how
and where to turn off the gas to the
range.
Before performing any service, turn
off the gas supply by closing the gas
shut-off valve and turn off the elec-
tricity to the oven.
Keep igniters clean and dry for
proper lighting and performance of
the burners.
Keep appliance area clear and free
from combustible material.
In the event that a burner goes out
and gas escapes, open a window or
a door. Wait at least five minutes
before using the unit.
Do not obstruct the flow of air. Your
kitchen must have an adequate
supply of fresh air to ensure proper
combustion and ventilation.
When cooking, set burner controls
so that the flame does not extend
beyond the bottom of the pan.
Always turn panhandles inward so
they do not extend over adjacent
work areas, burners or the edge of
the range.
Always check the positions of the
control knobs to make certain the
range or top surface burners are off
when you are finished cooking.
Be sure that the oven cool air intake
(located above the door) and the
oven exhaust vent (located below
the door) are unobstructed at all
times.
Position oven racks in desired loca-
tions when the oven is cool. If a rack
must be repositioned after the oven
is already hot, be certain the pot
holder does not contact a hot
heating element in the oven.
Before using the Self-Clean mode,
remove the broiler grill and pan,
oven racks, oven rack guides and
any other utensils.
Clean only those parts listed in this
book.
Cooling fan should be operating
during the Self-Clean mode. If you
notice that the cooling fan is not
operating, contact a Wolf authorized
service center before using Self-
Clean mode again. Cooling fan will
turn on automatically about 10
minutes after Self-Clean mode is
initiated.
Do not use commercial oven
cleaners
or oven liner protective
coatings on any part of the oven.
Do not use abrasive or caustic
cleaners or detergents on this appli-
ance as these may cause permanent
damage. Do not use aerosol
cleaners as these may be flammable
or cause corrosion of metal parts.
Do not clean the
oven gasket,
because r
ubbing or moving the
gasket
may eliminate the required
tight door seal.
Do not touch heating elements or
interior sur
faces of oven.