Filter
Top Products
7
Anti-tip Bracket Installation
To reduce risk of range tipping, secure range with a
properly installed anti-tip bracket.
1. Measure 3
1
/2 inches from back wall on right and left
side of cabinet cutout. Mark measurements on floor
and draw a straight line connecting marks.
2. Position anti-tip bracket.
• If range is installed beside cabinet(s), place anti-tip
bracket with back edge on line drawn on floor and
side of bracket against cabinet.
• If range is not installed beside cabinet(s), position
range where it will be installed. Draw a line along
side of range on floor from front to back. Remove
range. Place anti-tip bracket with back edge over
line drawn 3
1
/2 inches from back wall and side of
bracket over line drawn along side of range on floor.
• Anti-tip bracket can be installed on either right or
left side.
or
3. Mark 2 hole locations in anti-tip bracket.
4. Drill 2 holes.
• If drilling into wood, use a
3
/32 inch drill bit.
• If drilling into concrete, use a
3
/16 inch masonry drill
bit and insert plastic anchors.
5. Secure bracket to floor using screws supplied.
6. Slide range into position.
7. Remove range storage drawer and confirm anti-tip
bracket is engaged with range leveling leg.
Level Range
Carefully level range using legs provided. Range must be
level to cook and bake uniformly.
• Place a level on top oven rack or on top of range when
leveling.
• Leveling legs must be extended a minimum of
¼ inch (6mm) to engage anti-tip bracket.
1. Extend leveling legs so when range is moved into
position range top clears counter top.
2. Slide range to where it will be installed.
• Position range so that rear leveling legs do not
engage anti-tip bracket.
3. Turn leveling legs to level range.
• Turn legs clockwise to decrease range height or
counter clockwise to increase range height.
• Adjust rear leveling leg that engages anti-tip bracket
first. Leveling leg can not be adjusted while in
bracket. After adjusting leg that engages anti-tip
bracket, slide range forward until leg engages
bracket, and adjust other legs.
4. Replace storage drawer.
Removal and Replacement of Range
1. Disconnect power to range.
2. Slide range forward.
3. Unplug range cord and place range aside.
4. Remove anti-tip bracket.
5. Install anti-tip bracket into new location using
instructions provided with bracket or see “Anti-tip
Bracket Installation” section in this manual.
6. To reinstall range, follow instructions in “Installation”
section of this manual.
CAUTION
To avoid damaging oven door, do not lift or move range
by oven door handle. Glass can break.