Filter
Top Products
Page 28
PROGRAMMING THE BREWER (cont.)
PROGRAMMING FUNCTIONS - LEVEL 2 (cont.)
L/R SPRAY OZ/M
This function allows the operator to view or to enter
the actual flow rate coming out of the sprayhead for
each side of the brewer. This is NOT used to control
the actual flow rate, but to tell the internal controller
how fast the water is flowing.
Procedure to adjust the sprayhead flow rate set-
ting:
1. Press and hold the right hidden button until the
display reads SET LANGUAGE. Press the right hid-
den button until the display reads L SPRY OZ/M.
The number represents what the brewer thinks is
the flow rate out of the left sprayhead.
2. If the actual flow rate of the sprayhead is known
but is different than the number on the display, use
the (-) and (+) to enter the correct flow rate.
3. Press and release DONE. The display will now
read R SPRY OZ/M. The number represents what
the brewer thinks is the flow rate out of the right
sprayhead.
4. Repeat step #2 for the right sprayhead.
5. When finished, press and release DONE to advance
to the next function screen, L BYPS OZ/M: XX.X. To
exit programming and return to the MAIN SCREEN,
press and release either ON/OFF pad.
R SPRY OZ/M: XX.X
(-) DONE (+)
L SPRY OZ/M: XX.X
(-) DONE (+)
L BYPS OZ/M: XX.X
(-) DONE (+)
40119 071107