Filter
Top Products
Page 33
PROGRAMMING THE BREWER (cont.)
PROGRAMMING FUNCTIONS - LEVEL 2 (cont.)
ENABLE ADS
This function allows the operator to choose whether
or not to display an advertising message. An ad can be
saved to the brewer by either writing the ad using the
programming commands, or by entering the ad into
the brewer using an AD CARD. This message will be
displayed when the brewer is not in use.
Procedure to Enable/Disable Ads:
1. Press and hold the right hidden button until the
display reads SET LANGUAGE. Press the right hid-
den button until the display reads ENABLE ADS. The
YES or NO will be flashing to indicate the current
selection.
2. Press and release the NO button to disable this
function, or:
3. Press and release the YES button to enable this
function.
4. When finished, press and release DONE to save
the new setting and advance to the next function
screen.
5. If NO was selected, the display should now read
ENABLE CLEAN. To exit programming and return to
the MAIN SCREEN, press and release either ON/OFF
pad.
6. If YES was selected, the display should now read
2 LINES 16 CHARS AVAILABLE, and then SCROL
THRU ALPHA, NEXT -> NEXT LETTER, and then
WRITE TOP LINE ?. The ad can be up to 32 char-
acters long, 16 per line. The ad will be written in
two steps, first the top line, then the bottom line.
7. To write the top line of a new ad, press and release
YES. To skip the top line and only write a bottom
line, press and release NO and proceed to step
13.
8. The display will now read A with a flashing cursor
below it. Press and hold the SCROLL button to scroll
through the alphabet and available characters. When
the desired character is shown on the display, press
and release NEXT to move to the next character in
the top line.
9. Repeat step 8 until the top line is complete.
10. Press and release DONE. The display should now
read WRITE BTM LINE?.
11. To write the bottom line of the new ad, press and
release YES.
12. To skip the bottom line, press and release NO.
a. If neither a top nor bottom line was written, the
display should now read ENABL CLEAN ?.
b. If only a top line was written, the ad will be
displayed followed by SAVE? Proceed to step 16.
13. The display will now read A with a flashing cursor
below it. Press and hold the SCROLL button to scroll
through the alphabet and available characters. When
the desired character is shown on the display, press
and release NEXT to move to the next character in
the bottom line.
14. Repeat step 13 until the bottom line is complete.
15. Press and release DONE. The display will now show
the written ad, and then SAVE?
16. To cancel saving the ad, press and release NO. The
display should now read ADVERTISEMENT NOT
SAVED! and then will return to the WRITE TOP
LINE ? screen.
17. To correct or edit the ad, press and release EDIT.
The display should now read WRITE TOP LINE?
Repeat steps 10 though 17.
18. To save the ad as it is shown, press and release
YES. The display should now read ADVERTISEMENT
SETUP COMPLETE, and then ENABL CLEAN. To
exit programming and return to the MAIN SCREEN,
press and release either ON/OFF pad.
40119 071107