Filter
Top Products
8
Figure 3
-
5
Fan Guard Shown Installed
(SteamChef 3.1 Shown)
F. Install the Fan Guard and Air Diverter
• See Figure 3-5
1. Hold the fan guard so that the large ends of the keyhole slots are towards the bottom of the
steamer.
2. Place all four large end openings of the keyholes over the mounts located on the rear wall of the
steamer.
3. Pull it down so that the narrow ends of the slots are pulled tight over the mounts. See Figure 3-5.
4. Place the air diverter onto the fan guard as shown.
G. Install the Slide Racks
• See Figure 3-6. Each rack has four loops: two at
the top and two at the bottom.
1. Hold the slide rack so the ends of the hanger
loops are toward the side of the cooking
compartment.
2. Slide one rack into the compartment with loops
toward one side.
3. Hook the loops over the top and bottom pins.
4. Repeat steps 1 to 3 for the other racks.
Figure 3-3 KleanShield
Installation
(SteamChef 3.1 shown)
FIT UP OF
KLEANSHIELD
PIPE
Figure 3
-
6
Slide Rack
Figure 3-4 KleanShield
Drain
Legs
AIR DIVERTER
FAN GUARD SHOWN
PULLED DOWN TO
LOCK IT IN PLACE
FAN GUARD
LARGE END OF KEYHOLES
AT BOTTOM