Filter
Top Products
12
water to supply the reservoir. To use a separate conditioned water supply, use the layout
shown in Figure 3-11.
i. The steamer has two 3/4-inch GHT fittings, one for the water
reservoir and one for the condenser. See Figures 2-1 and 2-2.
A Filter Washer (dirt filter) is supplied installed in each of the water
inlets. See Figure 3-9.
1. Construct all supply lines up to the 3/4-inch NHT fittings.
2. Flush the water supply lines before connecting them to the
3/4-inch fittings.
3. Test Water Supply Lines
a. Check all connections for proper tightness.
b. Remove the control side panel to inspect water connections inside the steamer.
c. Open the water supply valves.
d. Check all lines and connections for leaks, both inside and outside the steamer.
SteamChef
Water Reservoir
Water Connection Pressure Reducer
(
if required)
Main Water
Shut
o
ff Valve
Main Cold
Water Supply
Air/Water Column
(
if required)
Check Valve
Condenser
Water Connection
Figure 3-10 Cleveland Range Single Water Supply Arrangement
SteamChef
Water Connection
Condenser
Water Connection
Pressure Reducer
(
if required)
Main Water
Shut
o
ff Valve
Cold Tap Water
Supply
Air/Water Column
(
if required)
Check
Valve
Conditioned* Cold
Water Supply
Water Reservoir
Figure 3-11 Cleveland Range Separate Water Supply Arrangement when Using
Separate Conditioned Feed Water Supply
* “Conditioned” indicates water that has been filtered or treated by a Cleveland Range approved method
to meet or exceed the water quality standards listed in the Warranty
Figure 3
-
9
Filter Washer
(P/N 110987 Shown)