Filter
Top Products
13
1. After connecting the gas supply, check the piping
and connections for leaks using a soap and water
solution. The presence of bubbles indicates a leak,
tighten or replace connections as appropriate.
Warning: Do not use any naked flame to check for
leaks.
2. Adjust the test point pressure or supply pressure to
the value which is appropriate for the gas type.
3. The operation of the appliance must be tested
when installation is completed.
4. Turn on the appliance gas controls and light each burner individually and in combi-
nation. Check for a well defined blue flame without any yellow tipping. If any
abnormality is evident then check that the burner cap is located properly and the
injector nipple is aligned correctly.
5. Check the minimum burner setting by quickly rotating the gas control knob from
the maximum to the minimum position, the flame must not go out. If adjustment is
required carry out the “minimum burner setting adjustment" procedure described
6. If satisfactory performance cannot be obtained, the installer shall check the installa-
tion and notify the local gas supply authority for a gas supply problem, or if it is an
appliance problem, our Customer Service Centre should be called to obtain the
nearest authorized Delonghi Service Agent.
Figure 1.12
Figure 1.11
gas pipe
cooker
rear protection
WARNING, This appliance IS NOT
SUITABLE for installation with a hose
assembly.