Filter
Top Products
53
BURNERS
■
They can be removed and washed only with
soapy water. Detergents can be used but
must not be abrasive or corrosive.
■
Do not use abrasive sponges or pads.
■
Do not put in dishwasher.
■ After each cleaning, make sure that the
burner-caps, as well as the burners, have
been well wiped off and CORRECTLY
POSITIONED.
■ It is essential to check that the burner flame
distributor F and the cap C has been
correctly positioned (fig. 8.1) - failure to do
so can cause serious problems.
■ Check that the electrode S (fig. 8.1) is
always clean to ensure trouble-free sparking.
■ Check that the probe T (fig. 8.1) next to
each burner is always clean to ensure
correct operation of the safety valves. Both
the probe and ignition plug must be very
carefully cleaned.
Note:
The electrode S must be very carefully cleaned. To avoid damage to the
electric ignition do not use it when the burners are not in place.
Figure 8.1
F
C
S
TRIPLE RING BURNER
■ The triple ring burner must be correctly positioned (see fig. 8.2); the burner
rib must be located in position as shown by the arrow.
■ The burner correctly positioned must not rotate (fig. 8.3).
■ Then position the cap A and the ring B (fig. 8.3).
A
B
Figure 8.2 Figure 8.3
T