Filter
Top Products
Chapter 10 Configuring your instrument by using wizards
Page 10.3
10.4 Quick-start Guide ( Set-up Wizards )
Wizard Measurement Task Page
Density 1
• Gas density measurement (nominated as density ‘A’) from a
single transducer that is connected to “Density input 1”.
10.6
Density 2
• Gas density measurement (nominated as density ‘B’) from a
single transducer that is connected to “Density input 1”.
10.8
Density 1 & 2
• Gas density measurements (nominated as density ‘A’ and
density ‘B’) from two transducers that are connected to “Density
input 1” and “Density input 2”.
SG 1
• Specific gravity measurement (nominated as SG ‘A’) from a
single transducer that is connected to “Density Input 3”.
10.10
SG 2
• Specific gravity measurement (nominated as SG ‘B’) from a
single transducer that is connected to “Density Input 4”.
10.11
SG 1 & 2
• Specific gravity measurements (nominated as SG ‘A’ and SG
‘B’) from two transducers that are connected to “Density input 3”
and “Density input 4”
10.12
Line density
• Density ‘A’
• Density ‘B’
10.13
Base density
• Base density ‘A’
• Base density ‘B’
10.16
Specific gravity
• SG ‘A’
• SG ‘B’
10.18
Temperature
• Line temperature
• Density temperature ‘A;
• Density temperature ‘B’
10.20
Pressure • Line pressure 10.22
Transmitters
• Live nitrogen measurement from an analogue input
• Live carbon dioxide measurement from an analogue input
• Live energy measurement from an analogue input
10.24
Special Calc. • Special equations 1 and 2 10.27
Analogue outputs
•
10.28
Alarms • User defined alarms 10.29
Multi-view • Multi-page multi-view
10.30
Full Setup • A collection of wizards for configuring a whole system
10.31