Filter
Top Products
Chapter 11 Configuring by using the menus
Page 11.3
11.4 What Sections 11.5- 11.18 tell you
Each section tells you how to configure one parameter. The format of each section is:
x (Where necessary) a statement which tells you what information you must have to configure the
parameter.
x (Where necessary) a block diagram showing how the instrument uses information from the transducers
(“Live Data”) and information you give it (“Fixed Data”) to calculate the value of the parameter.
x A diagram which shows that part of the menu system which you use to configure the parameter.
Sections 11.17 (Configuring other parameters) and 11.18 (Configuring Multiview) have a slightly different format
from the others because of the special nature of the topics they deal with.
The table on page 11.2 lists the items which you can configure and, for each, the calculations (if any) which are
involved in obtaining the value of the item.
In the menu diagrams, where an item is shown in brackets, the actual value or setting appears in the
menu at that point. For example:
(Value)
(Units)
(Live or set)
The display shows the actual value of the parameter.
The display shows the actual units.
The display shows whether the parameter is LIVE or SET.