Filter
Top Products
Each fault code is listed in the chart below for prefi nished
and integrated models.
HOW TO RECOGNIZE A FAULT CODE
When a fault code is displayed, the
will
continuously beep every second until the POWER button
is pressed.
For Prefi nished Models
A fault code is indicated in the Electronic Display, with a
spanner, letter and a number beside it, for example,
“F1” or “U1”.
For Integrated Models
A fault has occurred when the light above the START/PAUSE
button is red. The lights on the wash program indicator
signal which fault code has occurred, for example,
a “F1” fault code is
HOW TO ATTEND TO A FAULT CODE
1. Press the POWER button to remove the fault code.
2. If the fault code and continuous beeps cannot
be removed by pressing the POWER button, turn the
power off at the power supply.
3. We recommend you check the chart below and
correct the fault where possible.
4. After attending to the fault, turn the
on at the power supply.
5. If the fault code and continuous beeps remain,
turn the water and power supply off to the
.
6. When calling your Fisher & Paykel Authorized
Service Center advise them of the fault code that has
appeared on the
.This information will
help the Authorized Service Center respond better to
your request.
If you then have any questions about operating the product,
please contact our Fisher and Paykel Customer Care Center.
FAULT CODES
FAULT CODES
PREFINISHED INTEGRATED
F1
F2
F3
F4
F9
U1
POSSIBLE CAUSES
Flood switch has
been activated.
Motor problem.
Temperature sensor
failed.
Faulty temperature
sensor or element.
Electronics
malfunction.
Fill fault.
WHAT TO DO
Turn the water and power
supply off to the
and call your Fisher and Paykel
Authorized Service Center.
Call your Fisher & Paykel
Authorized Service Center.
Ensure water coming in through
the inlet hose is not greater
than 149°F. You may need to
put a tempering valve on your
water supply.
Call your Fisher & Paykel
Authorized Service Centre.
Call your Fisher & Paykel
Authorized Service Center .
Turn the water
supply on.
Ensure the spray arm is on the
impeller. The spray arm must
be able to rotate about the
center. If the is
full of water, the water will
need to be manually removed.
17