Fisher & Paykel DishDrawer Dishwasher User Manual


 
fault codes
Fault Codes Possible Causes
What to Do
Prefinished Models Integrated Models
How to Attend to a Fault
Code
1. Press the POWER button to
remove the fault code.
2. If the fault code and
continuous beeps cannot be
removed by pressing the POWER
button, turn the power off at the
power supply.
3. We recommend you check
the chart below and correct the
fault where possible.
How to Recognize a Fault
Code
When a fault has occurred, the
will continuously
beep every second.
The fault code will be displayed
on the Electronic Display for
prefinished and on the inside
control panel for integrated
models.
Each fault code is shown in the
chart below for prefinished and
integrated models.
If you have any questions about operating the product, please contact
our Fisher & Paykel Customer Care Center.
F1
F2
F3
F4
F9
U1
Flood switch has
been activated.
Motor problem.
Temperature sensor
failed.
Faulty temperature
sensor or element
Electronics
malfunction.
Fill Fault
Turn the water and power supply to the
off and call your Fisher & Paykel Authorized Service
Center.
Call your Fisher & Paykel Authorized Service Center.
Ensure water coming in through the inlet hose is not
hotter than 149
o
F. You may need to install a tempering
valve on your water supply.
Call your Fisher & Paykel Authorized Service Center.
Call your Fisher & Paykel Authorized Service Center.
.
Turn the water supply on.
.
Ensure the spray arm can rotate about the center, and
if the is full of water, it will need to be
emptied manually.
4. After attending to the fault,
turn the on at the
power supply.
5. If the fault code and
continuous beeps remain, turn
the water and power supply off
to the .
6. When calling your Fisher &
Paykel Authorized Service Center
advise them of the fault code
that has appeared on the
. This information
will help the Authorized Service
Center respond better to your
request.